Carpet Gripper Strip S/A
Carpet Gripper Strip (Self-Adhesive) is used under carpet gripper rods under gripper rods to raise them to the correct height. Each one comes with a Self-Adhesive backing that can be applied to most sub-floor materials for a quick and easy installation.
These are essential for use with our MuteMat range, this is because their heights are found above 10mm, and this will leave a dip around the perimeter of the room when you are installing the Gripper Rod directly to the floor. Their installation is purely aesthetical, and to level the flooring.
Information
- 5mm x 30mm x 10m.
For raising Gripper Rods to an appropriate height, helping to avoid dips around the perimeter. - Self-adhesive backing for a straightforward install.
- Does NOT include the gripper rod, these will need to be sourced independently.
Installation Guide
Make sure to peel the paper covering off to expose the self-adhesive face, be careful not to pull off this self-adhesive in the process.
Carpet Gripper Strip must be installed on to a clean surface, one that is debris and oil free, so that it remains in place.
Gripper Rods to be tack-nailed into the Carpet Stripper Strip to hold it in place.
Downloads
Sound insulation advice for Part E
Soundproofing Walls